I am trying to link an Open/Close Sensor 2843-222 as a controller to a Micro On/Off 2443-222 as a responder.
I am using the Micro On/Off without any attached switch, simply to open or close the circuit through the controller.
I would like the Micro On/Off module to be in OFF mode when the Open/Close Sensor is in the Closed state (when magnet is within ½). I know that the closed state of the sensor is reflected as an ON condition in ISY.
Although I can apparently (at least to some extent, subject to some questions) link the two devices so that the Micro On/Off module is in ON mode when the Open/Close Sensor is in the Closed state, despite repeated attempts I cannot do it the other way around. Is there something about these two devices that makes it impossible to do it the other way around as I would prefer?
I am following these instructions from the Manual:
Make Micro Module a Responder (Set button)
Note: you must perform these steps before reinstalling the wall switch, outlet or fixture.
1) Press and hold controller Set button until it beeps
Controller LED will start blinking
You will have four minutes to complete the next steps before linking mode times out
2) Adjust load connected to Micro module to desired brightness level (even off)
3) Press and hold Micro module Set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Load connected to Micro module will respond appropriately
BTW, I realize that I would be able to create a program in the ISY to effect this result, but I do not want to do so because this is intended to serve as a failsafe irrespective of the ISY.
Thanks in advance for any assistance you can provide.
I am using the Micro On/Off without any attached switch, simply to open or close the circuit through the controller.
I would like the Micro On/Off module to be in OFF mode when the Open/Close Sensor is in the Closed state (when magnet is within ½). I know that the closed state of the sensor is reflected as an ON condition in ISY.
Although I can apparently (at least to some extent, subject to some questions) link the two devices so that the Micro On/Off module is in ON mode when the Open/Close Sensor is in the Closed state, despite repeated attempts I cannot do it the other way around. Is there something about these two devices that makes it impossible to do it the other way around as I would prefer?
I am following these instructions from the Manual:
Make Micro Module a Responder (Set button)
Note: you must perform these steps before reinstalling the wall switch, outlet or fixture.
1) Press and hold controller Set button until it beeps
Controller LED will start blinking
You will have four minutes to complete the next steps before linking mode times out
2) Adjust load connected to Micro module to desired brightness level (even off)
3) Press and hold Micro module Set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Load connected to Micro module will respond appropriately
BTW, I realize that I would be able to create a program in the ISY to effect this result, but I do not want to do so because this is intended to serve as a failsafe irrespective of the ISY.
Thanks in advance for any assistance you can provide.
Comment