Announcement

Collapse
No announcement yet.

Several devices stopped responding

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Several devices stopped responding

    I found that I suddenly have 4 devices (2 outlets & 2 dimmer switches) that no longer respond to either my hub or my USB controller/indigo.
    I've tried everything I can think of - turned breakers off & back on, factory reset etc. They simply won't communicate. Deleted one switch from Indigo and attempted to add it again - 'no response from device'. These devices all work manually fine, just no communication. Also, they're in different areas of the house.
    This stuff has been stable for a couple years - nothings changed. Frustrated!
    Last edited by deco; 01-04-2019, 02:30 PM.

  • #2
    Are these legacy single-band modules? If so, check your access points (or whatever dual-band units you are using as a signal bridge between the two halves of your split-single phase electric service) to see if one has failed or was moved.

    If everything is dual-band, look for some source of active signal interference on the circuits where the PLM and Hub are plugged in.

    Comment


    • #3
      If you do have 2443 Access Points. The hardware revision 2 versions. Are built on the same main board as the 2413S/U PLM. They have a reputation of failing after two years old.
      I had both of my 2443 Access Points fail. I did rebuild the power supplies in both of them and they are working again.

      Comment

      Working...
      X