Until recently, all of my cameras have been sending the motion sensed alarm emails until 2 days ago when one stopped. Tried resetting and restoring etc to no avail. When I try to submit a change to the alarm setting I get a message "400 Bad Request"...."Can't parse request". Any suggestions?
-
-
Mine was working last night, then today, NOTHING. The log shows motion detection. My test emails send. But not motion detected emails. VERY ANNOYING -
Any help here is appreciated ... I started running with this issues immediately after upgrading to the 56 firmware (I also applied the upgrade to the UI).Comment
-
Just installed my Insteon outdoor ip camera. It works fine except I cannot get it to send email on motion detection
The mail setup tests ok yet nothing happens. It did upload and send pictures once but I cannot seem to get it working again Any suggestionsComment
Comment