I have a micro module attached to an ordinary switch controlling a light. Most of the time it works fine both thru the switch or also as a member of a scene. But it switches to momentary mode. When I look at it in Houselinc it thinks it is still in latching mode, but when I push the set button it responds with two beeps indicating momentary mode. I then reset it via the set button sequence and it's fine for a while again. I thought it might be related to a re synch, but I'm not 100% sure. Any suggestions? And can I reset it using Houselinc if it happens. I've tried but that doesn't seem to work.
- Welcome to the Insteon Forum. If this is your first visit, be sure to check out the FAQ by clicking the link above. Registration is required before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment