I have a hub2 controlling two external on/off switches and several dimmer modules. Once I got the phases and extenders set up it works properly.
I want to add a 2477S switch. When I tried the android app failed (see below)
I've tried the following without solving the problem:
I performed a factory reset.and got the long tone.
I added the device using the android app.
Control of the load (an incandescent light) using the paddles is OK.
The app reads the status of the load correctly.
If the load is on and I try to turn it off using the app, I can hear the relay click and the load blinks off briefly but then turns back off.
Similarly if the load is off and I turn it on using the app, the load blinks on briefly.
After about 4 minutes the switch buzzes.The behavior is unchanged.
I've tried this with two different switches with the same result.
I want to add a 2477S switch. When I tried the android app failed (see below)
I've tried the following without solving the problem:
I performed a factory reset.and got the long tone.
I added the device using the android app.
Control of the load (an incandescent light) using the paddles is OK.
The app reads the status of the load correctly.
If the load is on and I try to turn it off using the app, I can hear the relay click and the load blinks off briefly but then turns back off.
Similarly if the load is off and I turn it on using the app, the load blinks on briefly.
After about 4 minutes the switch buzzes.The behavior is unchanged.
I've tried this with two different switches with the same result.
Comment