I am trying to program my new 2466 ToggleLink to accept x-10 commands. I follow the instructions in the manual:
1) Press and hold ToggleLinc’s Set button until it beeps (about 3 seconds).
ToggleLinc’s status LED will blink.
You will have 4 minutes to complete the next step before linking mode times out.
2) Using an X10 controller, send the X10 address you want to assign to ToggleLinc Relay followed by the ON command three times.
For example, to assign the address A1, you would send A1-ON-A1-ON-A1-ON.
3) Once ToggleLinc Relay has received the sequence, it will exit linking mode.
ToggleLinc will double-beep.
2466 then accepts TURN ON command from X-10 controller but will NOT respond to a TURN OFF command from the same controller. The controller being use will control other X-10 devices. Manual switch works OK.
Where am I going wrong?
Buddypup
1) Press and hold ToggleLinc’s Set button until it beeps (about 3 seconds).
ToggleLinc’s status LED will blink.
You will have 4 minutes to complete the next step before linking mode times out.
2) Using an X10 controller, send the X10 address you want to assign to ToggleLinc Relay followed by the ON command three times.
For example, to assign the address A1, you would send A1-ON-A1-ON-A1-ON.
3) Once ToggleLinc Relay has received the sequence, it will exit linking mode.
ToggleLinc will double-beep.
2466 then accepts TURN ON command from X-10 controller but will NOT respond to a TURN OFF command from the same controller. The controller being use will control other X-10 devices. Manual switch works OK.
Where am I going wrong?
Buddypup
Comment