I am almost done with my construction on my home and just installed the insteon switches. My electrician is about to put up flood lights that I will supply. I have been reading up on the various forums that it's possible to get a flood light with motion sensor that works both with the insteon switch (to turn on and off) and also so the flood light will be activated by motion when the insteon switch is in off mode through the use of a Micro On/Off. My guess is that the Micro On/Off is connected to the Motion sensor piece of the flood light so when the motion sensor triggers, it send a signal to the Micro On/Off which then triggers the Insteon Switch to the on mode. If someone has done this, what do you set up the Micro On/Off as (controller, responder, both?), any other settings you should apply? Also, what connections should be made from the motion sensor to the Micro On/Off? I appreciate any tips anyone can provide
- Welcome to the Insteon Forum. If this is your first visit, be sure to check out the FAQ by clicking the link above. Registration is required before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment