I have a 2477 and a 2466, both are non-dimming. Both switch boxes have power, common, and ground, therefore I did not use the "traveler" cables at all. The 2466 controls the load, the 2477 red is capped, Through trial and error I linked the 2477 to the 2466 and both switches turn the light on or off. I cannot for the life of me get the two switches to stay synced as far as the LED indicators. My solution was to turn the LED off.
Using Android, the hub does not see the 2466. I am not sure if that is because the 2466 is not dual band. I did try entering the hex address, doesn't see it (lots of beeping though). Not the end of the world I thought, the hub does see the 2477. So when I use Android to turn the 2477 on and off why doesn't it control the 2466. My trial and error above was to make the 2477 the controller and the 2466 the responder, unless I am not understanding that.
Using Android, the hub does not see the 2466. I am not sure if that is because the 2466 is not dual band. I did try entering the hex address, doesn't see it (lots of beeping though). Not the end of the world I thought, the hub does see the 2477. So when I use Android to turn the 2477 on and off why doesn't it control the 2466. My trial and error above was to make the 2477 the controller and the 2466 the responder, unless I am not understanding that.
Comment