Hello,
I've got a 2457D2 unit, firmware version R3.6 and it's not responding to commands 0x2E (lamp on to level at ramp rate) and 0x2F (lamp off at ramp rate). All other commands - lamp on, lamp off, brighten, dim are working fine.
I've implemented these commands just fine with other units, albeit with older firmware (R3.2).
Anyone know if they've removed these commands or changed them with the newer firmware?
It's a very useful command, and I'll be quite disappointed if the newer version modules no longer allow it.
FWIW, setup is iRule to a Global Cache GC100 controlling a 2413S serial modem which is controlling the module. No issues with the control chain as other commands are working just fine.
Any insight you can provide will be appreciated.
Thanks much,
Brian
I've got a 2457D2 unit, firmware version R3.6 and it's not responding to commands 0x2E (lamp on to level at ramp rate) and 0x2F (lamp off at ramp rate). All other commands - lamp on, lamp off, brighten, dim are working fine.
I've implemented these commands just fine with other units, albeit with older firmware (R3.2).
Anyone know if they've removed these commands or changed them with the newer firmware?
It's a very useful command, and I'll be quite disappointed if the newer version modules no longer allow it.
FWIW, setup is iRule to a Global Cache GC100 controlling a 2413S serial modem which is controlling the module. No issues with the control chain as other commands are working just fine.
Any insight you can provide will be appreciated.
Thanks much,
Brian
Comment