I have an Hub 2242-222 with the blinking red light problem. I can not access the hub with iPhone.
I have tried powering off, waiting 30 seconds, powering on, several times. That did not work.
The next step is apparently to try a network reset, But instructions to that do not address the KEY QUESTION .. outcome of following the network reset procedure … if I network reset, will that AXE everything in my hub and app settings?
Am I going to then need to go around my house doing factory resets on all devices, re-link everything to my hub again, set up everything in the app again, naming and linking all devices again, setting up scenes again?
I have tried powering off, waiting 30 seconds, powering on, several times. That did not work.
The next step is apparently to try a network reset, But instructions to that do not address the KEY QUESTION .. outcome of following the network reset procedure … if I network reset, will that AXE everything in my hub and app settings?
Am I going to then need to go around my house doing factory resets on all devices, re-link everything to my hub again, set up everything in the app again, naming and linking all devices again, setting up scenes again?
Comment