Welcome to the Insteon Forum. If this is your first visit, be sure to
check out the FAQ by clicking the
link above. Registration is required
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Are you saying that the modules are turning 'On' without any input from a user? ...or are they a part of a scene and only one unit is working as expected?
Hi, I experienced something like this when installing an Insteon Remote Control Micro On/Off Switch Adapter 2443-222. I wired a manual Levitron on-off switch to the yellow sense wire to be attempt to manually switch the micro module. What I found, however, was the neon light in the Levitron switch "leaked" a low current voltage to the sense wire even when off and it caused the micro module to always be "on". If I switched the light switch on, the micro module would go off, but it seems that a lighted manual switch is not compatible with the sense wire of the micro module.
I used a relay in my microcontroller-controlled garage door opener because I needed my project to mimic pushing a physical button which required switching capabilities, not the ability to send an output voltage from the board [URL]https://www.krogerfeedback.ltd/[/URL]
Comment