It does sound bad.
I picked up a few of the 2822-292 Retail Labeled ones and they are V2.3. So the 2.4 would be more recent....
BLH
Junior Member
Last Activity: Today, 03:20 AM
Joined: 03-28-2014
Location:
-
If the LED is always Off. Even after a Factory reset and the outlet is verified OK.
It has probably died and you should see if it is warranty for...Leave a comment:
-
When you plug it in and the Set Button is not being held. The LED on the side should be On dim if the relay is Off and bright if the relay is On.
...Last edited by BLH; 08-12-2017, 11:58 AM.Leave a comment:
-
ISY994i is not software. It is a full featured Insteon controller.
You mentioned using an Insteon Controller. Is it a 2245-222 HUB with the android...Leave a comment:
-
For the 2245-222 HUB II.
The older 2242-222 HUB has different C designations.
C7 looks like it maybe in the Zero Crossing circuit....Last edited by BLH; 07-31-2017, 03:17 AM.Leave a comment:
-
The 2242-522 is for AUS/NZ as pointed out.
It has a different Insteon RF frequency of 921MHz. Ours is 915MHz.
It will not receive or control...Leave a comment:
-
Is this a new problem and originally the Fanlinc did all three speeds or a new setup that never had all three speeds?
I have seen threads here and...Leave a comment:
-
There is an 18 page post on the UDI forums.
On the 2413S PLM failures and how we fixed them.
The most important thing is C7 and C13 should...Leave a comment:
No activity results to display
Show More
Leave a comment: