scenes still programmed?

[rajung]

motion sensor and light switch still linked.
I recently had to replace a dead hub and re installed all the devices.I had one motion sensor in garage that I had linked to a wall switch by creating a scene.
Motion detected , and lights would come on for a 30 sec time.
Now with no scenes created, since new hub install, it still does this. nothing under my app does it show a scene for either switch or sensor.
thanks

[rajung]

Thanks, will work on un linking them.
I really did not like the way they acted anyway, so now is a good time.Motion sensed and lights came on for 30 sec, which was fine.
But using the switch or app they still went out, always had to turn lights back on when working in garage.
They would stay on by using wall switch or app, but only until motion was detected by sensor and then back to the 30 rule.
This took a long time for me to figure out what was going on and why.
Thanks again.

[Deverson]

Are you using Stringify? I’ve played with it but not a whole lot. It looks like a nice app.