I am trying to set up a scene through Insteon for Hub app where my smoke bridge will turn on lights and turn off an outletlinc that has a space heater plugged into it. I created the scene with the smoke bridge as a controller and all lights and the outlet as a responder. The lights I set the state to on, the outlet to off. When I turn the scene on through the app, I was expecting the lights to turn on and the outlet off, but they all turn on. I tested this out by modifying a scene where a switchlinc is controlling an insteon LED bulb. I changed the bulb on status to "off" through the scene setup in the insteon for hub app. I expected the bulb to turn off when I turn the switch on, but it still turns the bulb off. How do I create scenes through the app that will turn some devices on and some off? I know how to do this manually through the set buttons on the devices themselves, but want to keep all scenes setup through the hub to it is easier to add/remove devices later.
- Welcome to the Insteon Forum. If this is your first visit, be sure to check out the FAQ by clicking the link above. Registration is required before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.