Announcement

Collapse
No announcement yet.

New commands with Hub PLM firmware A3?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • New commands with Hub PLM firmware A3?

    this is a developer question. Trying to register an open/close module

    I am transmitting the following command and getting the following response. 02 5C is an unknown plm command to me and the insteon documentation.

    TX: 02 62 36 E5 CC 0F 10 00 (Insteon ID Broadcast)

    RX: 02 5C 36 E5 CC 30 1E 73 23 10 (???)

    Can anyone shed any light on the response? what is the 02 5C PLM command
    Author of the Mark Sandler Insteon Homeseer Plugin (HS2 & HS3)

  • #2
    I get this response when I send to a device ID that does not exist. I notice that the response is a DirectAck and that hopsLeft is 0.
    It has the same format as a 0x50 INSTEON Standard Message Received.
    Last edited by srveit; 02-18-2018, 01:52 PM.

    Comment


    • #3
      Originally posted by srveit View Post
      I get this response when I send to a device ID that does not exist. I notice that the response is a DirectAck and that hopsLeft is 0.
      It has the same format as a 0x50 INSTEON Standard Message Received.
      That makes a lot of sense in my case. Turns out the user didn't put the open/close sensor into linking mode before trying to register it. thanks for the reply
      Author of the Mark Sandler Insteon Homeseer Plugin (HS2 & HS3)

      Comment

      Working...
      X