Announcement

Collapse
No announcement yet.

2457d2 won't load sense

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    2457d2 won't load sense

    I have a 2457d2 version 3.6 installed. It works perfectly with the button and control via insteon commands. My problem is the module seems to not be load sensing. I think it used to but at this point I can't be certain. I have a 3 way incandescent bulb installed. I tried enabling load sense by holding the set button until the light starts blinking and then pressing it 3 times quickly. No benefit.

    rkshack

    #2
    One of the manuals I have. Shows hold the Set Button until the LED flashes. Then Tap the Set Button three times to enable Load Sensing. Is that what your trying? It also said below 3.6 did not support Load Sensing. I would think your 3.6 would.

    I also have a few other dated manuals and they make no mention of Load Sensing. Could not see a hardware revision reference to indicate what each covered.
    Last edited by BLH; 08-24-2020, 07:03 AM.

    Comment

    Working...
    X